AEG BP5014301M User Manual page 36

36 www.aeg.com
Problem
The core temperature sensor
does not operate.
There is water inside the
oven.
The steam cooking does not
work.
The steam cooking does not
work.
It takes more than three mi-
nutes to empty the water
tank or the water leaks from
the steam inlet opening.
It takes too long to cook the
dishes or they cook too
quickly.
Steam and condensation
settle on the food and in the
cavity of the oven.
The display shows "C2".
The display shows "C3".
The display shows "F102".
Possible cause
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
There is too much water in
the tank.
Lime obstructs the hole.
There is no water in the tank.
There are lime deposits in
the oven.
The temperature is too low
or too high.
You left the dish in the oven
for too long.
You want to start the Pyroly-
sis or Defrost function, but
you did not remove the core
temperature sensor plug
from the socket.
The cleaning function does
not operate. You did not
fully close the door, or the
door lock is defective.
• You did not fully close
the door.
• The door lock is defec-
tive.
Remedy
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
Deactivate the oven and
wipe the water with a cloth
or sponge.
Check the steam inlet open-
ing. Remove the lime.
Fill the water tank.
Clean the water tank. Refer
to "Cleaning the water
tank".
Adjust the temperature if
necessary. Follow the advice
in the user manual.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Remove the core tempera-
ture sensor plug from the
socket.
Fully close the door.
• Fully close the door.
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows
"F102" again, contact the
Customer Care Depart-
ment.