Master Section - Vestax PMC 500 Owner's Manual

MASTER SECTION

@6 M ASTER BALANCE 1&2
Adjusts the signal balance of the L to R side of the
outputs from MASTER OUT 1&2 JACKS
rear panel.
@7 M ASTER LEVEL 1&2
Adjusts the signal level outputs from MASTER OUT
1&2 JACKS on the rear panel.
@8 M ASTER 1&2 CUE SWITCH
Used to send the signal from the MASTER OUT
1&2 to the monitor section for headphone
monitoring.
@9 M ASTER 1&2 CUE LED
This LED is illuminated when the MASTER 1&2
@8
CUE SWITCH is on.
#0 M ASTER LEVEL METER
This LED bar level meter indicates the L and R
outputs.
#1 M ETER ASSIGN SWITCH
Use this switch to select either MASTER OUT 1 or
2 to be shown in the MASTER LEVEL METER #0 .
#2 P OWER LED
This LED will be illuminated when the POWER
SWITCH
#3 A UX SEND LEVEL
Adjusts the output level sent to an external effects unit
connected to the AUX SEND JACK $9 on the rear
panel. When the crossfader is used, this signal is taken
after the crossfader but before the master fader. This
makes a variety of techniques possible, such as the
application of echo to a cut out in which the crossfader
would be used.
#4 A UX RCV LEVEL
Adjusts the input level from an external effect unit
connected to the AUX RCV JACK
panel.
#5 A UX CUE ON/OFF SWITCH
Sends the signal of external effects unit connected to
the AUX SEND JACK to the MONITOR section for
headphone monitoring.
#6 A UX CUE LED
This LED will be illuminated when the AUX CUE
SWITCH#5 is on.
#7 A UX RCV LEVEL METER
This LED bar level meter indicates the level of the
AUX RCV JACK signal.
#8 B OOTH OUT EQ (HI/LOW)
Adjusts the HI and LOW frequencies for the
BOOTH OUT.
%2
on the
#9 B OOTH OUT LEVEL
Adjusts the output level of BOOTH OUT.
$0 M UTE SWITCH
This switch mutes the signal being sent to BOOTH
OUT.
$1 M UTE LED
This LED will be illuminated when the MUTE
SWITCH $
$2 M ASTER 1&2 & BOOTH OUTPUT LEVEL
SELECTOR (ATTENUATION).
Located under the top panel, this switch adjusts the
output level for Master 1&2 in addition to the Booth out
put level. The PMC-500 is pre-set to a 0dB output
level but may be changed to -10dB.
8
%4
is on.
0
is on.
%
0 on the rear