Standard Set-Up - Universal Remote Control Star Light SL-7000 Operating Manual

Programming the Remote,
C. Standard Set-Up:
Step 1: Turn on the device ( TV, VCR, Cable Box, Satellite Receiver, etc. ) that you
wish to operate.
Step 2: On the Star Light universal remote control, press the corresponding
button
DEVICE
button simultaneously.
Note: SET will appear in the LCD.
Step 3: Locate the three digit code number for your brand of equipment from the
code lists found on pp. (
Note: If the brand list contains more than one code number,
select the first code listed.
Step 4: Point the remote control at the devise turned on in Step1 and press in the
three digit code number selected in Step 3.
Note: SET # # # will appear in the LCD.
Your device will turn off when the correct code has been selected. If the
device fails to turn off, go back to Step 3 and select the next three digit
code for your equipment, and press in the code number.
Note: Repeat the above step until the device turns off. When
the device turns off proceed to Step 5.
Step 5: Press the DEVICE button (TV, VCR, CATV, SAT, Audio, Aux) on the
remote control to store the three digit code that turned off your equipment.
Note: PASS will flash in the LCD indicating that the code has
been stored.
Step 6: Test the remote control functions with the code just stored.
Example: Power, Channel Up, Volume Up, etc. If any of the buttons do not
perform as they should, please repeat from Step 2 using the next three digit
code until the right code is found.
Step 7: To program other devices into the corresponding Device button of the
remote control, repeat the above steps with the respective devices and Device buttons.
7
Continued
(
(TV, VCR,CATV, SAT,Audio,or Aux)
). Example: TV codes-Sony
15 31
)
and
the MUTE
,etc.
001,003