Table of Contents
Advertisement
SETTING OVEN CONTROLS
Setting broil
Use the broil feature to cook meats that require direct
exposure to flame heat for optimum browning. Use the
broiler drawer and rack along with the broil pan and
insert when broiling. The broiler drawer offers 3 different
broil rack positions.
WARNING
• DO NOT use oven or broiler drawer for storage.
Items placed in oven or broiler drawer will catch fire.
• Should an oven fire occur, close the door and drawer
and turn the oven OFF. If the fire continues, use a fire
extinguisher. DO NOT put water or flour on the fire.
Flour may be explosive.
CAUTION
• Always use oven mitts when using the oven or
broiler drawer . When cooking, the oven, cooktop,
broiler drawer and racks will become very hot which
can cause burns.
• The broil pan and insert allows grease to drain and be
kept away from high heat of the broiler. DO NOT use
broil pan without insert. DO NOT cover insert with
aluminum foil; the exposed grease could ignite.
Broil pan
Broiler drawer rack
NOTES
• For medium doneness, position the broiler rack close
to the oven burner (upper or middle positions). For
well-done foods such as chicken, lobster tails or thick
cuts of meat, position rack further away from oven
burner (lower position).
• For optimum browning, close broiler drawer and
preheat broiler 5 minutes before adding food.
12
To set broil
1. Slide broiler drawer out until drawer stops.
2. Remove broiler pan and insert (See Fig. 1).
3. If needed, reposition broiler rack in broiler drawer
Broil pan insert
always pick up
4. If needed, change broiler rack position by tilting front
broil pan and insert
from sides
5. Place insert on broiler pan and place prepared food
Fig. 1
6. Push in and turn the Temperature Control knob to
7. Broil on one side until food is browned; turn and broil
8. When finished broiling, turn knob to OFF.
3 rear locating
hole positions
Fig. 2
while the range is still cool. Be sure to read broiler
rack position recommendations (See Notes).
of rack up & pulling rack completely out from locating
holes in rear of broiler drawer (See Fig. 2). Reposition
back of rack in one of 3 locating holes and allow front
of rack to slide down into the corresponding slots in
front of broiler drawer (Fig. 3). Be sure rack is level
before broiling.
on insert. Place broiler pan and insert with food into
broiler on drawer rack as shown (See Fig. 1). Slide
broiler drawer completely into range.
BROIL.
on other side.
tilt up front of rack
to remove and adjust
3 front
slot positions
Fig. 3
Advertisement
Table of Contents
