Table of Contents
Advertisement
Cleaning the cooktop and surface burners
(cont'd)
To clean the surface burner heads
For proper gas flow it may be necessary to clean the
burner ports. Before cleaning be sure the gas burners are
turned off. First use a clean DAMP cloth to soak up any
spills. Remove any food from the burner ports using a small
nonabrasive brush like a toothbrush and afterwards wipe up
using a damp cloth. For stubborn soils located in the burner
ports, use a small gauge wire or needle to clean.
Any spill on or around the electrode must be carefully
cleaned. Take care not to hit the electrode with any thing
hard or it could be damaged.
Removing and replacing surface burners
To remove burners
1. Remove shipping screws with a Phillips Head
screwdriver. See Fig. 1 for screw locations.
2. Tilt the burner at the end closest to the support bar
until the locator tab is released (front burners tilt right,
rear burners tilt left). Move the burner towards the
back of the range. This will separate it from the gas
valve at the front of the range.
To replace burners
1. Slide the burner tube over the gas valve at the front
of the range (front burners fit over the right valve,
rear burners fit over the left valve on each side of the
range).
2. Tilt burner so that the locating tab will slide into
the slot on the support bar. Make sure burners are
properly seated on support bar and are level.
3. Replace shipping screws.
rear burners
shipping
screws
locating
tab
burner
support bar
Replacing oven light (some models)
CAUTION
Be sure the range is unplugged and all parts are COOL
before replacing oven light. Wear a leather-faced glove
for protection against possible broken glass.
The interior oven light bulb is located at the upper left rear
of the oven cavity.
To replace the oven light bulb
1. Turn electrical power off at the main source or unplug
the range.
2. Replace bulb with a new 40 watt appliance bulb.
3. Turn power back on again at the main source (or plug
the appliance back in).
4. The clock will then need to be reset. To reset, see
"Setting the clock" in this Use & Care Guide.
CARE & CLEANING
locating
tab
front burners
Fig. 1
gas
valves
15
Advertisement
Table of Contents
