Friedrich MWM24Y3J Installation And Operation Manual page 8

Remote Control Instructions
1
START / STOP
Press this button to turn on the unit .Press this button again to turn off the unit.
2
Press this button to decrease set
to rapidly decrease set temperature. In AUTO mode, set temperature is not
adjustable.
3
:
Press this button to increase set temperature. Hold it down for 2 seconds or more
to rapidly increase
adjustable.
4
FAN :
AUTO
This button is used for setting Fan Speed in the sequence that goes from AUTO,
,
5
MODE :
Each time you press this button, a mode is selected in a sequence that goes from AUTO,
COOL,DRY, FAN,and HEAT
*Note: Only for models with heating function.
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not
be displayed on the LCD, and the unit will automatically select the suitable operation
mode in accordance with the room temperature to make indoor room comfortable.
SENSOR (SAVE)
6
Press this button to turn on
and automatically adjusts maintaining that room ambient until pressed again which
cancels the SENSOR(SAVE)
7
CLOCK :
Pressing CLOCK button,
present time. Holding down either button above 2 seconds increases or decreases the
time by 1 minute every 0.5 second and then by 10 minutes every 0.5 second. During
blinking after setting, press CLOCK button again to confirm the setting, and then
will be constantly displayed.
Remote Controller Description
:
temperature. Hold it down for 2 seconds or more
set temperature. In AUTO mode, set temperature is not
,
,
to
then back to Auto.
Auto
Low speed
* , as the following:
COOL
AUTO DRY
:
SENSOR(SAVE)
function.
blinks.
Medium speed
*
FAN HEAT
function. Saves room ambient temperature
Within 5 seconds , pressing + or - button adjusts the
6
High speed