Cleaning The Cabinet; Maintenance Cleaning - True Manufacturing Company TDC-47 Installation Manual

Tdc & thdc series dipping cabinet
Table of Contents

Advertisement

True Food Service Equipment, Inc.

MAINTENANCE CLEANING

CLEANING: (Before cleaning out the interior locate the
drain hose in the rear grill area and be prepared to
open the line and drain the water into a pan or floor
drain. This will be the same for TDC and THDC models)
The lid can be removed from the cabinet. (See image 1
for TDC models and image 2 for THDC models). If the
lid has been removed, wash it with nonabrasive soap or
detergent and water. Use the bare hand to feel and
dislodge any caked soil.
Rinse thoroughly with clean water. Do not use hard,
rough cloths that will scratch the surface of the lid.
Dry with a clean, damp chamois. The interior can be
cleaned but, before doing so make sure the drain at the
bottom of the cabinet is open and the drain hose in the
rear grill is at a floor drain.
MAGNETIC ICE BREAKER (ONLY ON TDC MODELS):
Magnetic ice breaker were designed to provide a fast and
effective way to remove the frost from the wall above the
product. Frost accumulation reduces the refrigeration
effectiveness as it increases in thickness.
The frequency at which to clean the ice breaker is a
function of the store operation as a starting point.
Thaw and clean at the beginning of each day.
Thaw under warm water or on a counter top at room
temperature until ice breaker is flexible and clear of frost.
Wipe dry to prevent returning moisture to cabinet.
NOTE
Magnetic ice breakers are soft and flexible at room
temperature but, they will become relatively rigid when they
have been exposed to low temperature from the cabinet.
DO NOT FOLD MAGNETIC ICE BREAKERS!
Reinstall the ice breakers by forming around corners.
The ice breakers are magnetic and they will attach tightly
to the wall and resist sliding in place. To overcome this
apply from one end and roll into place. (See image 3).
13
MAINTENANCE, CARE & CLEANING
............ www.truemfg.com ............
1
The lid on TDC models can be removed
by lifting it out of the hinge bracket.
2
The lid can be removed by simply
lifting it out.
Magnetic Frost Shield
3
(ONLY FOR TDC MODELS).
Hinge Bracket
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thdc-6

Table of Contents