Setting The Clock (Fc824 Only); Program On/Off Timer(S)(Fc824 Only) - Rinnai FC824 Installation And Operation Manual

Setting the Clock: (FC824)
When the appliance is first plugged in and then
turned on, the digital display will show "- -:- -"
After 10 seconds the Digital Display will turn off.
Example: setting the clock to 10:35 A.M.
1. Press the Set Time Button once, the Clock
Indicator will glow.
2. Press and hold the "
begin to change first, then the time will change by
whole hours. Release the button when AM 10:00
shows on the Digital Display. Confirm that you have
selected AM. A small indication on the left hand side
of the Digital Display should indicate the AM setting.
Then press and hold the "
the button when AM 10:35 shows. If you go past AM
10:35, then the " " button can be used to change
the time settings in reverse.
3. Press the Set time button five times to lock in the
time. The Clock and Timer indicators will go out. After
10 seconds the Digital Display will turn off.
Before programming the Timer(s), ensure the clock
time has been set.
18
" button; the minutes will
" button again, release
NOTE
Fan Convector Manual
Programming the On/Off Timer(s) (FC824)
Example: setting Timer 1 to heat between 7:10 A.M to
9:00 A.M.
1. Press the Set Time Button twice. The digital
display will show AM 6:00. Timer 1 Indicator will glow.
2. Press the " " button until AM 7:00 appears.
Release the button, then press it again until AM 7:10
appears. (Press the "
7:10.)
3. Press the Set Time button again, the Timer 1 OFF
indicator will glow. Press the "
9:00 appears.
4. Press the Set Time button three times to lock in
the programmed time. The digital display will show
the current time. After 10 seconds the digital display
will turn off.
Timer 2 is programmed in the same way simply
choosing Timer 2 instead of Timer 1. Timers can be
programmed to operate for any 2 periods within 24
hours. The programmed time must be selected and
locked in within 1 minute of the Timer Indicators
glowing, otherwise the adjustment will not be saved .
" button if you go past AM
" button until AM
NOTE