Maruyama MS332 Instruction Manual page 23

3. Move the throttle lever away from the MIN. position, about 1/3
of the way toward the MAX. position.
THROTTLE LEVER
MIN.
Some engine applications use a remote-mounted throttle control
rather than the engine-mounted throttle lever shown here. Refer
to the instructions provided by the equipment manufacturer.
4. Turn the engine switch to the ON position.
EXCEPT ELECTRIC
STARTER TYPES
ENGINE SWITCH
ON
MAX. MIN.
1/3 POSITION
ELECTRIC STARTER TYPES
ON
ON
ON
ENGINE SWITCH
5. Operate the starter.
RECOIL STARTER:
Pull the starter grip lightly until you feel resistance, then pull
briskly in the direction of the arrow as shown below. Return the
starter grip gently.
Direction to pull
Do not allow the starter grip to snap back against the engine.
Return it gently to prevent damage to the starter.
ELECTRIC STARTER (applicable types):
Turn the key to the START position,
and hold it there until the engine
starts.
If the engine fails to start within 5
seconds, release the key, and wait at
least 10 seconds before operating the
starter again.
Using the electric starter for more
than 5 seconds at a time will overheat
the starter motor and can damage it.
This type of overheating is not
covered under warranty.
When the engine starts, release the
key, allowing it to return to the ON
position.
6. If the choke lever was moved to the CLOSED position to start
the engine, gradually move it to the OPEN position as the
engine warms up.
OPEN
ENGLISH
STARTER GRIP
ENGINE SWITCH
(applicable types)
CHOKE LEVER
CLOSED
START
START
OPEN
5