Electrical Connections - King Canada KC-3010NB Instruction Manual

10” sliding tile saw with laser guide

Hide thumbs

Table of Contents

ALL ELECTRICAL CONNECTIONS MUST BE DONE BY A QUALIFIED ELECTRICIAN. FAILURE TO COMPLY MAY RESULT IN

SERIOUS INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE TILE SAW DISCONNECTED FROM THE

POWER SOURCE. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY!

POWER SUPPLY

WARNING: YOUR TILE SAW MUST BE CONNECTED TO A 120V,

15-AMP. BRANCH CIRCUIT. FAILURE TO CONNECT IN THIS WAY

CAN RESULT IN INJURY FROM SHOCK OR FIRE.

120V OPERATION

As received from the factory, your tile saw is ready to run for 120V

operation. This tile saw is intended for use on a circuit that has an

outlet and a plug which looks like the one illustrated in Fig.1.

EXTENSION CORDS

The use of any extension cord will cause some loss of power. Use the

following table to determine the minimum wire size (A.W.G-American

Wire Gauge) extension cord. Use only extension cords which accept

the tool's plug.

For circuits that are further away from the electrical circuit box, the wire

size must be increased proportionately in order to deliver ample voltage

to the motor. Refer to Fig.2 for wire length and size.

ON-OFF SWITCH AND RESET BUTTON

This tile saw comes with a toggle switch (A) Fig.3 which turns the motor

and the water pump on simultaneously (water pump plug must be

connected to the motor quick-connect plug (C) or else the water pump

will not work). To turn machine on, push the toggle switch to the "ON"

or push the toggle switch to the "OFF" to turn off the machine.

This tile saw is equipped with a circuit breaker reset button (B) Fig.3. If

the circuit is tripped and the motor stops, push the toggle switch to the

"OFF" position. Wait 10-15 minutes for the machine to cool down and

then press the circuit breaker reset button, finally push the toggle switch

to the "ON" position to turn machine on again.

If this fails, try using a dedicated circuit without any other electrical

devices plugged to it, or have a qualified electrician check your

electrical panel.