Tripp Lite SmartPro SMART3000RMOD2U Owner's Manual page 5

Mounting
Mounting (4-Post Rackmount)
The UPS includes rackmount shelf kits for 4-post rackmounting. The user must determine the fitness of hardware and procedures before mounting. If
hardware and procedures are not suitable for your application, contact the manufacturer of your rack or rack enclosure. The procedures described in
this manual are for common rack and rack enclosure types and may not be appropriate for all applications.
WARNING! The UPS system is heavy. Use caution when lifting and mounting. User must properly stabilize the UPS when lifting and mount-
ing.
1
Connect the two segments of each shelf using the included
A
screws and wing nuts . Leave the screws slightly loose so
that the shelves can be adjusted in the next step.
2
Adjust each shelf to fit the rack, then mount them in the lowest
available space of the rack with the screws, nuts and washers
B
provided . Note that the support ledges should face inward.
Tighten the wingnuts that connect the shelf segments.
3 C
Attach mounting ears
UPS using the screws provided
forward.
4
Using an assistant (if necessary), lift the UPS and slide it onto
the mounting shelves. Attach the UPS to the rack by inserting
the appropriate hardware
into the rack rails.
2-Post (Telecom) Mounting
If you mount the SMART3000RMOD2U in a 2-post rack, it requires the addition of a Tripp Lite 2-Post Rackmount Installation Kit (Model:
2POSTRMKITWM, sold separately).
1
A
Attach mounting ears
B
UPS using the screws provided
backward.
2
Using an assistant if necessary, lift your UPS and slide it onto
the mounting shelves. Attach your UPS to the rack by passing
the screws, nuts and washers provided
ears and into the rack rails.
to the front mounting holes of the
D
. The ears should face
E
through the mounting ears and
to the front mounting holes of your
C
. The ears should face
D
through its mounting
1
2
A
B
B
3
C
4
E
1
B
2
D
5
B
B
A
D
A C