Figure 7-6: Confirmation Screen - Cisco Linksys WVC210 User Manual

Wireless-G PTZ Internet Camera with Audio
Date. Enter the current date.
Time. Enter the current time.
Time Zone. Select the time zone for the Camera's location.
Network Time Protocol. If you want to update the Camera's time through an NTP (Network Time Protocol) server
on the Internet, click the first checkbox. When the NTP feature is enabled, the daylight savings option will be
available. If you want to adjust the Camera's current time for daylight savings, click the second checkbox.
LAN Settings
Configuration Type. If the Bridge will obtain an IP address automatically from a DHCP server, then select
Automatic Configuration - DHCP. If you will assign the Camera a static IP address, then select Static IP
Address, and complete the IP Address, Subnet Mask, Gateway, and DNS fields.
IP Address, Subnet Mask, Gateway, Primary DNS, Secondary DNS. Complete these fields if the Camera will
use a static IP address. You need to enter at least one DNS address.
Wireless Settings
SSID. Enter the network's SSID or network name here.
Network Type. Select the network's mode, Infrastructure or Ad-hoc.
Channel No. If the Camera is set to ad-hoc mode, select its channel setting from the drop-down menu.
Security. To use WEP encryption, click the Enable radio button. You will be asked to confirm that you want to
enable wireless security for the Camera. Click the OK button. Then click the Edit Security Settings button. For
more information, go to the "Security Settings" section. To disable WEP encryption, click the Disable radio
button.

Figure 7-6: Confirmation Screen

To save your changes, click the Apply button. To cancel any unsaved changes, click the Cancel button. To get
additional information about the screen's features, click the Help button.
Security Settings
Configure the Camera's WEP encryption settings on this screen. Make sure all devices on your wireless network
use the same settings.
Default Transmit Key. Select which WEP key (1-4) will be used when your network's access point or wireless
router sends and receives data.
Chapter 7: Using the Wireless-G Internet Camera's Web-based Utility 44
Setup