Setup; Figure 7-5: Basic Screen - Cisco Linksys WVC210 User Manual

Wireless-G PTZ Internet Camera with Audio

Setup

The Basic screen will appear. You have six tabs available:
• Basic. To configure the Camera's basic, LAN, and wireless settings, use the Basic screen.
• Image. Customize the video settings on the Image screen.
• Maintenance. Reset the Camera's factory defaults and upgrade the Camera's firmware from this tab.
• Users. Designate user's level of access and manage passwords for the Camera on this screen.
• DDNS. DDNS (Dynamic Domain Name System) lets you assign a fixed host and domain name to a dynamic
Internet IP address.
• FTP Upload. Manage the uploading of images to an FTP site from this tab.
• Options. The e-mail alert options, Universal Plug and Play (UPnP) setting, and Alternate Port settings are
configured on the Options screen.
• Pan/Tilt. Set and calibrate the Camera's pan and tilt options from this screen.
• Status. Status information and a log are displayed on this screen.
To save your changes, click the Apply button. To cancel any unsaved changes, click the Cancel button. To get
additional information about a screen's features, click the Help button.
Basic
The Basic screen allows you to alter the Camera's settings, including the network and wireless configuration.
Device Settings
Device ID. Displayed here is the Camera's identification name, which is used by the Camera and the Utility to
exchange data.
Camera Name. You may assign any name to the Camera. Unique, memorable names are helpful, especially if you
are using multiple Cameras on the same wireless network. You can enter up to 15 characters.
Description. Enter information about the Camera in this field. You can enter up to 32 characters.
LED Operation. This feature allows you enable or disable the Camera's LEDs.
Chapter 7: Using the Wireless-G Internet Camera's Web-based Utility
Setup

Figure 7-5: Basic Screen

43