Toto WASHLET TCF4914E Series Instruction Manual page 62

Troubleshooting
Trouble
The dryer
temperature is low
Stops in the middle
of use
Trouble
For not  ushing
The toilet does not
 ush even when the
button is pressed
The bowl unit
does not clean
automatically or
timing is delayed
(Auto  ushing)
The toilet  ushes on
its own
*1 Available only when "FLUSH" button is located on the top side of the remote control.
62
Warm air drying
Please check
Is the dryer temperature set to low level?
The feature stops automatically after about 10 minutes of continuous use.
Does the seat switch have dif culty detecting?
Sit back on the toilet seat. If you get up slightly from the seat, or sit forward
on the seat, the seating switch may temporarily stop detecting your
presence.
Flushing*
Please check
Is the shutoff valve fully open?
Has a water failure occurred?
Use a bucket to flush water.
Are you pressing the button repeatedly?
(After pressing the  ush button, operation will not be accepted for about 10 to
20 seconds.)
Is "Auto  ushing" set to "OFF"?
Even if "Auto  ushing" is set to "ON", it is not available in the following
instances
About 60 seconds after the toilet is  ushed.
Wait about 60 seconds and flush the toilet with the remote control.
When the time spent sitting on the toilet seat or standing in front of the bowl
unit is less than about 6 seconds.
Flush with the remote control.
When staying in front of the bowl unit after standing and using the toilet.
The water flows after a maximum of about 20 seconds from when you
leave the bathroom.
The seat switch will not turn on unless you sit on the seat properly.
Sit back on the toilet seat.
The timing for the "Auto flushing" can be changed.
(After about 10 seconds → after about 5 or 15 seconds)
Is "Auto flushing" set to "ON"? → You can turn it "OFF".
Does the seat switch or the body sensor have dif culty turning on or
detecting?
Sit back on the toilet seat. If you lift your hip off the toilet seat during use
or sit forward on it, the seat switch may not turn on, and thus auto flushing
may occur during use.
1
Set to "ON".
Ref.
Page
24
-
9
Ref.
Page
15
56
-
38
16
16
-
9
38
38
9