Toto WASHLET TCF4914E Series Instruction Manual page 6

Safety Precautions
Refrain from sitting on the seat for long periods.
It may cause low-temperature burns.
To prevent the following persons from getting a moderate temperature burn during use, other
person should turn off the toilet seat heater and set the dryer temperature to "Low".
Young children, the aged and other users unable to set the temperature appropriately
themselves.
The ill, physically disabled and others who do not have freedom of movement.
Those using any medicines that cause drowsiness (sleeping or cold medicine), those who have
been drinking heavily, anyone severely fatigued and anyone else liable to fall asleep.
This is an electrical product. Do not install it anywhere water is likely to get on
the product or anywhere with humidity high enough that water is likely to form
on the surface of this product. When using the product in a bathroom, install a
fan or ventilation port and ensure good air  ow through the bathroom.
Failure to do so may cause  re or electrical shock.
Always connect the product to the cold water supply.
Connecting to hot water supply may result in burns and equipment damage.
Check that an appropriate ground is installed.
If the ground is not installed, if there is a breakdown or electrical current leak, the lack of a
ground could cause electrical shock.
For the ground, use copper wire with a ground resistance of 100 Ω max. and a diameter of 1.6 mm min.
* If there is no ground installed, ask the contractor who did the installation to install the ground.
Make sure that a properly grounded (3 prong) outlet has been installed.
Failure to install a grounded outlet could cause electrical shock in the event of a malfunction or
short circuit.
Insert the power plug securely into the outlet.
Failure to do so may cause  re, heat or short circuit.
Check that the power plug is waterproofed with silicone rubber.
A power plug that is not water-proofed may cause  re and electrical shock.
* If the power plug is not water-proofed, ask the contractor who did the installation to water-proof it.
To unplug, hold the power plug, not the power cord.
Do not unplug by pulling the power cord.
Pulling on the power cord may cause damage and result in  re or heat.
If the electric cord is damaged, avoid danger by having the manufacturer's
repair department or equivalent specialist replace it.
Always switch the breaker on the distribution board to OFF before
maintenance or inspection.
Failure to do so may cause electrical shock or malfunction.
Always switch the breaker on the distribution board to OFF before removing
the main unit
Failure to do so may cause  re or electrical shock.
6
WARNING
(Continued)