Recommendations For Mowing - Walker T27i Operator's Manual

Operating Instructions

RECOMMENDATIONS FOR MOWING

Do not mow around overhanging tree
branches or bushes at the same height as
the operator's torso and head where inad-
vertent contact may cause injury.
Avoid Low Hanging Branches
IMPORTANT: Operate the engine at full throttle
when mowing, to allow the engine to produce full
horsepower and to increase efficiency of the engine
cooling system.
•
Keep the mower deck and discharge chute clean.
•
Mow with sharp blades. A dull blade tears the
grass (resulting in poor lawn appearance) and uses
extra power (slowing the mowing speed).
•
It is preferable to cut grass when it is dry and not
too tall. Mow frequently and do not cut grass too
short. (For best appearance, cut off 1/3 or less of
existing grass height.)
40
DANGER
•
When mowing, operate the engine at full throttle
for the best cutting action and performance of the
grass handling system (GHS). Mowing with a lower
engine RPM causes the mowing blade to not cut
clean and tear the grass. The engine is designed
to be operated at full speed.
•
When mowing in adverse conditions (tall and/or
wet grass), mow the grass twice. Raise the mower
to the highest setting - 4 in. (102 mm) - for the first
pass and then make a second pass cutting to the
desired height.
•
Use a slow setting on the FSC for trimming op-
erations.
•
Make sure the mower is leveled properly for a
smooth cut. Refer to Deck Leveling in Assembly In­
structions.
•
Use an alternating stripe mowing pattern for
best appearance and vary the direction of the stripe
each time the grass is mowed to avoid wear patterns
in the grass.
•
Avoid damage to the grass by slipping and skid-
ding of the drive tires. Use smooth control move-
ments of the steering levers since the hydrostatic
transmissions are "power boosted controls" and jerk-
ing the levers can easily slip the tires. For sharp
turns, do not allow the inside wheel to stop and twist
on grass; pull inside steering lever into reverse for a
smooth "rolling" turn (one wheel rolling forward while
the other rolls backward).