TYAN S8020 Manual page 118

TpAbl1MemFlowPStateSync
TpIfAfterRunApFromAllAps
TpIfBeforeRunApFromAllCore0s
TpIfAfterRunApFromAllCore0s
TpIfBeforeAllocateS3SaveBuffer
TpIfAfterAllocateS3SaveBuffer
TpIfBeforeAllocateMemoryS3SaveBu
ffer
TpIfAfterAllocateMemoryS3SaveBuff
er
TpIfBeforeLocateS3PciBuffer
TpIfAfterLocateS3PciBuffer
TpIfBeforeLocateS3CPciBuffer
TpIfAfterLocateS3CPciBuffer
TpIfBeforeLocateS3MsrBuffer
TpIfAfterLocateS3MsrBuffer
TpIfBeforeLocateS3CMsrBuffer
TpIfAfterLocateS3CMsrBuffer
TpReadyToBoot
// PMU test points
TpProcMemPmuFailed
TpProcMemPhase1End
TpProcMemPhase2End
// ABL0 test points
TpAbl0Begin
TpAbl0End
= 0xE0E8, ///< Memory flow P-State
synchronization
= 0xE0E9, ///< After the BSP calls out to
run code on an AP
= 0xE0EA, ///< Before the BSP calls out
to
run code on an AP
= 0xE0EB, ///< After the BSP calls out to
run code on an AP
= 0xE0EC, ///< Before the S3 save code
calls out to allocate a buffer
= 0xE0ED, ///< After the S3 save code
calls out to allocate a buffer
= 0xE0EE, ///< Before the memory S3
save code calls out to allocate a buffer
= 0xE0EF, ///< After the memory S3 save
code calls out to allocate a buffer
= 0xE0F0, ///< Before the memory code
calls out to locate a buffer
= 0xE0F1, ///< After the memory code
calls out to locate a buffer
= 0xE0F2, ///< Before the memory code
calls out to locate a buffer
= 0xE0F3, ///< After the memory code
calls out to locate a buffer
= 0xE0F4, ///< Before the memory code
calls out to locate a buffer
= 0xE0F5, ///< After the memory code
calls out to locate a buffer
= 0xE0F6, ///< Before the memory code
calls out to locate a buffer
= 0xE0F7, ///< After the memory code
calls out to locate a buffer
= 0xE0F8, ///< Ready to boot event
= 0xE0F9, ///< Failed PMU training.
= 0xE0FA, ///< End of phase 1 memory
code
= 0xE0FB, ///< End of phase 2 memory
code
= 0xE0FC, ///< Abl0Begin
= 0xE0FD, ///< ABL 0 End
118
http://www.tyan.com