Table of Contents
Advertisement
4.3.6. Remote Keypad parameter editing function
This function allows the user to edit the parameters of Remote Keypad.
Remote Keypad parameter list
Title
Software version
f-01
Automatic comparing
f-02
It is recommended to set the automatic comparing function "f-02" to "
programming errors (caused by environmental circumstances, peripheral devices, etc.) will not be automatically
detected. This could result in an accident, if the inverter is operating with the wrong parameters.
Operating procedure
Key
LED indication
"copy"
→
"prot"
SFT
→
"f- "
"f- "
ENT
"f-01"
SFT
"f-02"
ENT
( "f-01"
"1"
SFT
→
"0"
ENT
→
"f-02"
- If the [ESC] key is pressed, Remote Keypad returns to previous status (except when executing).
- The memory protection function (write protection) can not protect Remote Keypad parameter.
- The memory initialization function initializes Remote Keypad parameter when "sys (selecting all memories)" is
selected.
Function
Display shows the software version of Remote Keypad.
displaying
Automatic comparing function can be turned on or off.
0: Not executing comparison after copying
function
1: Executing comparison after copying (default)
Warning
→
"comp"
< Selecting a desired function >
→
"clr"
Select "f- " (Remote Keypad parameter editing function) with the
[SFT] key.
< Entering the selected function >
→
"f-01"
After selecting "f- " with the [SFT] key, press the [ENT] key and
"f-01" appears in the display window.
< Selecting a parameter title to edit or display >
Each time the [SFT] key is pressed, the display changes
→
"f-02"
"f-01" Software version displaying
"f-02" Automatic comparing function
alternately.
< Entering a parameter title to edit or display >
If "f-02" is selected with the [SFT] key and the [ENT] key is
→
" 1"
pressed, the current value ("1": Executing comparison after copying
by way of example) appears in the display window. If "f-01" is
→
"v100" )
selected as parameter to display, the indication of Remote Keypad
software version appears as shown in parentheses.
< Changing a value of selected parameter >
Each time the [SFT] key is pressed, indication in the display window
→
→
" 0"
...
alternately changes between "1" and "0". However the software
version does not change.
< Executing edit parameter >
After selecting "0" (Not executing comparison after copying) with the
"0" (flashing)
[SFT] key, press the [ENT] key and Remote Keypad starts writing the
parameter value to its memory, and flashes the value in the display
window. When the writing is complete, indication of the display
returns to the parameter title ("f-02").
Description
1
" (default). When "
Key operation and description
- 15 -
E6581277
0
" is selected,
Advertisement
Table of Contents
