Table of Contents
Advertisement
Operating Instructions
Troubleshooting
Operation
„
„
Symptom
No power
Cannot operate
( common to wireless remote control,
controller)
Cannot operate using the wireless
remote control
Cannot operate using the controller
The unit turns in the opposite
direction to the one operated
44
Cause and solution
• Is the AC adaptor securely connected to the AC outlet?
• If the power plug of the AC adaptor connected properly?
• Is the LAN cable connected securely to the IP control LAN connector
<NDI|HX>?
• Is the network cable for the PoE+ (IEEE802.at) compatible power supply device
and the unit connected properly?
• Power may not be supplied if the total power limit is exceeded on power supply
devices that allow connections to multiple PoE+ terminals.
→ Refer to the operating instructions for the PoE+ power supply device.
• If the unit is connected to the controller, has it been connected properly?
→ Refer to the operating instructions for the controller.
• When performing operations from a wireless remote control
→ Also refer to the "Cannot operate using the wireless remote control" item.
• Is the power on?
→ If the unit's status display lamp is off or lights up orange, it means that the unit's
power is not on.
• The safe mode function may have been activated.
• Have the limiter functions been set?
• Has the unit you want to operate been selected properly?
• Have the remote control's batteries run down or have the batteries been installed
with their polarities reversed?
→ If the status display lamp does not blink even when the wireless remote control is
operated near the wireless remote control signal light-sensing area, it means that
the batteries have run down. Replace the batteries.
• Have the IR ID switches been set correctly?
• Is there a fluorescent light or plasma monitor near the unit and, if so, is the
wireless remote control signal light-sensing area exposed to its light?
• Is the unit connected to the controller properly?
→ Refer to the operating instructions for the controller.
• The user authorization and host authorization must be set to OFF when the AW-
RP120, AW-RP50 and AK-HRP200 remote camera controllers are connected in a
network.
• It may be necessary to upgrade the version of the controller so that the controller
will support the unit.
→ For details on upgrading, visit the support page on the following website.
http://pro-av.panasonic.net/
• When using an HTTPS connection, network connection with the AW-RP50, AW-
RP120, and AK-HRP200 will be disabled.
• Has the stand-alone (Desktop) installation setting been selected correctly?
• The reversal setting may have been established at the controller if the unit is
connected to the controller.
→ Refer to the operating instructions for the controller.
Reference pages
– – –
– – –
page 37
page 22
– – –
page 19
– – –
PDF page 22
PDF page 108
PDF pages 106 to 107
PDF page 23
– – –
page 37, page 41
page 35
page 19
PDF page 84
PDF page 85
– – –
PDF page 90
PDF page 95
PDF page 53
PDF page 81
– – –
Advertisement
Table of Contents
