Table of Contents
Advertisement
Setting the remote control IDs
The wireless remote control (optional accessory) is capable of operating
up to four units.
IDs are used to set which units are selected when the <CAM1>,
<CAM2>, <CAM3> and <CAM4> buttons on the wireless remote control
have been pressed.
• When operating a multiple number of these units using wireless
remote controls, set a different remote control ID for each control.
• When using one unit, set the remote control ID to "CAM1" unless the
setting needs to be changed.
Setting procedure
„
„
Operate the IR ID switches on the unit's rear panel, and select "CAM1",
"CAM2", "CAM3" or "CAM4" as the remote control ID. (→ page 37)
The IR ID switch settings "CAM1" to "CAM4" correspond to the <CAM1>
to <CAM4> buttons on the wireless remote control.
(The factory setting is "CAM1".)
<CAM1> to <CAM4> buttons
IR ID switches
Operating Instructions
41
Advertisement
Table of Contents
