Caso HCMG25 Original Operating Manual page 52

Take any packaging materials that are no longer required to "Green Dot" recycling
collection points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.
11.5 Setup
11.5.1
In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
• The device must be set up on a firm, flat, horizontal and heat-resistant surface with
sufficient load-bearing capacity for the oven and the maximum weight of the expected
food that is to be prepared in the oven.
• Choose the setup location in such a way that children cannot reach any hot surfaces on
the device.
• The device is not intended to be installed in a wall or a built-in cupboard.
• Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
• Ensure that the power cable does not hang down over a table or counter edge.
• The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
• The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
11.5.2
clearance of 30 cm is needed, and on the sides at least 20 cm distance to other
walls or units are needed.
caso HCMG 25
Setup location requirements:
Installation of the appliance
1) Select a level surface
providing enough distance
between the ventilation
slots and walls or other
a) The surface for placing
units.
the appliance must be at
b) The rear of the appliance
least 85 cm above the
floor.
must be facing a wall.
Above the appliance a
52