Fujitsu T1323SC010IN Operating Manual page 34

Important information
Before starting up
During installation and before operating the server, observe the instructions
●
on environmental conditions for your server.
If the server is brought in from a cold environment, condensation may form
●
both inside and on the outside of the server.
Wait until the server has acclimatized to room temperature and is absolutely
dry before starting it up. Material damage may be caused to the server if this
requirement is not observed.
Only transport the server in its original packaging or in packaging that
●
protects it from impacts and jolts.
In Japan and APAC, transporting the server in its original packaging does
not apply.
Installation and operation
This server should not be operated in ambient temperatures above 35 °C.
●
For servers with Advanced Thermal Design the ambient temperature can
increase to 40 °C or 45 °C.
If the server is integrated into an installation that draws power from an
●
industrial power supply network with an IEC309 connector, the power
supply's fuse protection must comply with the requirements for non-
industrial power supply networks for type A connectors.
The server automatically adjusts itself to a mains voltage, see the type label
●
of your server. Ensure that the local mains voltage lies within these limits.
This server must only be connected to properly grounded power outlets or
●
connected to the grounded rack internal power distribution server with
tested and approved power cords.
Ensure that the server is connected to a properly grounded power outlet
●
close to the server.
Ensure that the power sockets on the server and the properly grounded
●
power outlets are easily accessible.
The On/Off button or the main power switch (if present) does not isolate the
●
server from the mains power supply. In case of repair or servicing disconnect
the server completely from the mains power supply, unplug all power plugs
from the properly grounded power outlets.
34 Operating Manual
TX1320 M3