Page 1
Q U I E T S I D E A I R C O N D I T I O N E R S QSVSI-18A QSVSO-18A QSVSI-24A QSVSO-24A Thank you for choosing QUIETSIDE air conditioner. For correct operation, please read this owner's manual carefully before operating the unit and keep it carefully for consultation.
Notices for operation If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
Notices for use Working principle and special functions for cooling Principle: Air conditioner absorbs heat in the room and transmit to outdoor and discharged, so that indoor ambient temperature decreased, its cooling capacity will increase or decrease by outdoor ambient temperature. Anti-freezing function: If the unit is running in COOL mode and in low temperature, there will be frost formed ℉...
Page 8
Notices for use All the electrical work must be done by qualified personnel according to relative wiring regulation and this manual. The power supply is type Y connection.If the supply cord is damaged,it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. The rated voltage and the exclusive circuit must be used.
Page 9
(Image shown here is indicative only. Actual product you receive may differ)
Operation of wireless remote control Names and functions of wireless remote control Note: Be sure that there are no obstructions between receiver and remote controller; Don't drop or throw the remote control; Don't let any liquid in the remote control and put the remote control directly under the sunlight or any place where is very hot.
Page 11
Operation of wireless remote control Names and functions of wireless remote control Notice: This is a general use remote controller, it could be used for the air conditioners with multifunction; For some function, which the model dosen't have, if press the corresponding button on the remote controller that the unit will keep the original running status.
Page 12
Operation of wireless remote control Names and functions of wireless remote control Notice: This is a general use remote controller, it could be used for the air conditioners with multifunction; For some function, which the model dosen't have, if press the corresponding button on the remote controller that the unit will keep the original running status.
Page 13
Operation of wireless remote control Guide for operation- General operation 1. After powered on, press ON/OFF button, the unit will start to run.(Note: When it is powered off, the guide louver of main unit will close automatically.) 2. Press MODE button, select desired running mode. 3.
Page 14
Operation of wireless remote control About lock Press +and - buttons simultaneously to lock or unlock the keyboard. If the remote controller is locked, the icon will be displayed on it, in which case, press any button, the mark will flicker for three times.
Emergency operation Displayer indicator light control of indoor unit It's a special selective buttonfor the users ,who are not accustomed to the light at sleeping. Get the displayer indicator light on: When setting the light function,the mark will display on the remote controller screen by pressing this button.
Page 20
indoor will stop deliver air. (Within 2min) fan will water be vapo- rized rising.
Page 21
Installation Manual professional individual codes locating qualified professional individual circulated 98.42 in 39.37 in Make sure that the indoor unit installation should accord with installation dimension diagram requirements. Do not use the unit in the immediate surroundings of a laundry, bath, shower or a swimming pool.
Page 22
Installation Manual ground ground performed 4. The min. distance from the unit and combustive surface is 59.05 in. 5. The appliance shall be installed in accordance with national wiring regulations. An all-pole disconnection switch having a contact separation of at least 0.12 in in all poles should be connected in fixed wiring.
Install indoor unit Install the rear panel 1.Always mount the rear panel horizontally. Due to the water tray of indoor unit has been adopted the both-way drainage design, the outlet of water tray should be adjusted slightly down when installing, that is taking the outlet of the water tray as the center of a circle, the included angle between the evaporator and level should be 0 or more, that is good for condensing water drainage.
Page 25
98.43 inch 0.24in 0.37in 0.47 in 0.63in 0.75in...
Install outdoor unit Electric wiring Disassemble the handle on the outdoor unit right side plate. Handle Take off cord anchorage. Connect and fix power connect for 220~240V models cord and power cord to terminal block. N(1) 2 blue black brown Fix the power connection cable and power cord with yellow- green...
Page 27
Install outdoor unit Air purging and leakage test 1. Connect charging hose of manifold valve to charge end of low pressure valve (both high/low pressure valves must be tightly shut). Manifold Valve 2. Connect joint of charging hose to vacuum pump. 3.
Installation and Maintenance of Healthy Filter Installation Instructions 1. Forcibly pull the panel for a specific angle from the two ends of the front panel according to the arrow direction. Then pull the air filter downwards to remove it. (See Fig.a) Fig.
Page 32
QUIETSIDE CORPORATION www.quietside.com West Office 8750 Pioneer Blvd. Santa Fe Springs, CA 90670 USA Phone: 562-699-6066 Fax: 562-699-4351 East Office 6 Pine Hill Drive Carlisle, PA 17013 Phone: 886-243-6498/ 717-243-2535 Fax: 717-243-7917 TX Office 3001 Northern Cross Blvd. Suite 361...
Need help?
Do you have a question about the QSVSI-18A and is the answer not in the manual?
Questions and answers