Table of Contents
Advertisement
INSERTING THE BATTERY
Your Remington
ALKALINE battery, which are included in your pack.
1.
To open the battery compartment, turn the base of the unit
approximately 1cm clockwise (to the right) and pull it off.
2.
Insert the battery into the unit, positive end first.
3.
Replace the base and turn it 1cm anti-clockwise (to the left) to lock it
in place.
Battery Cautions
•
Using non-alkaline batteries will impair the unit's operating
performance.
•
The battery should not be left in the unit if it is not in use for long
periods.
•
To prevent battery corrosion, the unit should be stored in a dry
environment.
•
Dead batteries should be removed immediately and disposed of
properly.
•
Do not use rechargeable batteries with this appliance. The lower
voltage in rechargeable batteries impairs the performance of the
cutting unit.
HOW TO USE
To Remove Hair From The Nose
1.
Select the nose & ear trimmer.
2.
Turn the trimmer on.
3.
Insert the trimmer's cutting unit gently into the nostril.
4.
Rotate the trimmer in a circular motion around the opening of the
nostril.
5.
For best cutting efficiency, gently move trimmer in and out of the
nostril as you rotate the trimmer.
6.
Do not insert the trimmer more than 6mm into your nostril.
Note: Always remember to turn on the trimmer before you insert it into your
nose or ear to avoid painfully snagging hairs.
The Works trimmers are each powered by one "AA"
®
12
Advertisement
Table of Contents
