Table of Contents
Advertisement
•
Place one or two drops of oil on the blades. Turn the appliance on to distribute the
oil evenly, wipe off any excess oil.
REPLACING THE FOILS AND CUTTERS
To ensure continued high quality performance from your shaver, we recommend the foils
and cutters are replaced regularly.
Signs that your foils and cutters need replacing
•
Irritation: as foils get worn, you may experience skin irritation.
•
Pulling: as the cutters wear, your shave may not feel as close and you may feel the
cutter pulling your hair.
•
Wear through: you may notice that the cutters have worn through the foils.
TO REPLACE THE FOIL/CUTTERS
•
Remove the shaver head (pull the head up and off).
•
Fit the new head assembly over the hair pocket and press down to click into place.
BATTERY REMOVAL
This appliance contains batteries that are non-replaceable. When the battery is at the
end of its life, the appliance and battery must be properly disposed of at an official
recycling point.
We strongly recommend that a professional removes the rechargeable battery. Parts of
the shaver case, and tools have sharp edges and may cause injury if not handled
correctly.
•
Be aware of the risk of terminals of the battery being short-circuited by metal objects.
•
The rechargeable battery must be removed from the appliance before it is scrapped.
•
Disconnect the charging adapter before removing the battery.
1. Ensure the device is discharged of all power. To do this, switch it on and allow it to
run until it stops.
2. Remove any attachment.
3. Using a small screwdriver, carefully pry the two screw covers away from the bottom
housing.
4. Unscrew the two screws located on the bottom.
5. Starting at the top seam, carefully use a small flat screwdriver and, following the
seam, pry the top panel apart.
6. Unscrew the two screws located on front.
7. Using a small flat screwdriver, pry the bottom housing from the body.
8. Unscrew the two screws and remove front housing.
9. Gently pry open the latches of inner housing then remove the circuit board.
10. Disconnect the battery from the circuit board.
•
Do not attempt to operate the shaver once you have opened it.
9
Advertisement
Table of Contents
