Table of Contents
Advertisement
Step 1 - Nape of the Neck
1.
Use 3mm or 6mm setting.
2.
Hold the hair clipper with the blade teeth pointing upwards. Begin starting at
the centre of the head at the base of the neck.
3.
Slowly lift the hair clipper, working upwards and outwards through the hair,
trimming just a little at a time.
Step 2 - Back and Side of the Head
With the 9mm or 12mm setting in place, cut the hair at the back of the head.
Step 3 - Side of the Head
With the 9mm or 12mm setting in place, trim sideburns.
Step 4 - Top of the Head
1.
With the setting of your choice, cut the hair on top of the head against the
direction in which the hair normally grows.
2.
For longer hair on top, use scissors. Lift the hair on top of the head with
styling comb. Cut over the styling comb with the hair lifted or hold the hair
between the fingers to lift it and cut it to the desired length.
3.
Always work from the back of the head.
Step 5 - The Finishing Touches
1.
Use the hair clipper without an attachment comb for close trimming around
the base and sides of the neck.
2.
To produce a clean straight line at the sideburns, reverse the hair clipper.
Place the reversed hair clipper at right angles to the head, tips of the blades
lightly touching the skin and then work downwards.
CLEANING & MAINTENANCE
To ensure long lasting performance of your hair clipper, clean the blades and unit regularly.
NOTE: Ensure that the hair clipper is turned off and unplugged when cleaning.
After Each Use
1.
Ensure the hair clipper is switched off and disconnected from the mains
household power outlet.
2.
Brush the accumulated hair from the blades. Do not submerge the hair clipper in water.
3.
To clean the body of the unit, wipe with a damp cloth and dry immediately.
4.
Gently brush the remaining hairs away from the hair clipper comb and hair
clipper blade. Do not rinse the cutter assembly under water.
Every Six Months
At regular intervals the blade set should be removed and cleaned.
7
Advertisement
Table of Contents
