Table of Contents
Advertisement
Note: Do not apply excessive pressure as this damages the trimmer and may
cause skin injury.
To trim sideburns
1.
Select the detail trimmer.
2.
Turn the trimmer on.
3.
Gently guide the cutting unit to your sideburns holding the unit horizontally at
a 90 degree angle to the sideburns.
4.
Trim the sideburns moving the trimmer slowly and carefully, to ensure that you
do not accidently cut hairs that you do not intend to trim.
NOTE: It is not recommended that you use the trimmer to define or trim the
eyebrows.
CLEANING & MAINTENANCE
Both your detail trimmer and nose & ear trimmer are designed to give you years of
comfortable use. To ensure that you get optimal performance from your trimmers,
follow these simple cleaning and lubricating tips:
•
After each use, brush or blow accumulated hair from the cutting units.
Rinsing Your Trimmers
•
The heads of your trimmers are washable and can be rinsed with cool or
warm water. Simply twist the attachment head 1cm anticlockwise (to the
left), remove the head &/or blade (nose & ear trimmer) and rinse them under
the tap - do not use hot water. Do not allow water into the body of the
handpiece.
•
Afterward, shake excess water from the cutter head. Be sure to be careful
when handling the nose trimmer blades as they are sharp.
•
Replace the head in the same position as it was removed, turning it 1cm
clockwise (to the right) until it locks into place.
Lubricating the Cutters
•
After rinsing the attachment heads, apply a drop or two of lubricating oil or
sewing machine oil to the cutting teeth &/or blades (nose & ear trimmer).
•
Don't apply too much oil, or it may spray.
•
Finally, point the trimmer down and away from you, and turn it on. This
spreads the oil evenly and expels any excess.
THIS PRODUCT IS NOT SUITABLE TO USE IN THE BATH OR SHOWER.
This product conforms to radio frequency interference requirements
Any product purchased and used commercially carries a limited 90 Day Warranty.
12
Advertisement
Table of Contents
