Cleaning And Maintenance - Remington Style Series Manual

TRIMMING
• Slide up the trimmer release button to activate the trimmer.
• Hold the trimmer at a right angle to your skin.
• To retract the trimmer, push the top rear of the trimmer down until it locks under the
trimmer release button.
TIPS FOR BEST RESULTS
• Always hold the shaver at right angles to the skin so that all foils are touching the skin
with equal pressure.
• Use moderate to slow stroking movements. The use of short linear motions in
stubborn areas may obtain a closer shave, especially along the neck and chin line.
• DO NOT press hard against the skin in order to avoid irritation and damage to the foil
heads.

CLEANING AND MAINTENANCE

To ensure long lasting performance clean after each use.
1. Ensure the shaver is switched off.
2. Press the head release buttons and and pull the head upwards (FIG A).
3. Tap out any excess hair shavings (FIG B).
4. Rinse the cutters (underneath the shaving head) and the shaving head itself under
warm running water (FIG C).
5. Refit the shaving head once it is dry.
REPLACING THE FOILS AND CUTTERS
• To ensure continued high quality performance from your shaver, we recommend the
foils and cutters are replaced regularly.
Signs that your foil/s and cutter/s need replacing
• Irritation: as foils get worn, you may experience skin irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may feel the
cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the foils.
TO REPLACE THE FOIL
• Press the head release buttons and and pull the head upwards.
• Fit the new foil assembly over the hair pocket and press down to click into place.
5