Komatsu H70051 Series Operation & Maintenance Manual page 264

MACHINE OPERATIONS AND CONTROLS
1.
Set the cutting edge slightly downward from the horizontal.
2.
Drive the machine forward and dig soil and sand bit by bit
as if they are ripped off by tilting the multifunction mono-
lever slightly forward.
3.
Keep on driving the machine forward while adjusting the
digging depth by using the multifunction mono-lever.
When you perform digging by use of the bucket, avoid ap-
plying the digging force only to one side of the bucket.
LEVELING WORK
NOTICE
• Always drive the machine in reverse when performing leveling work.
When it is unavoidable to drive the machine forward for the leveling work, do not set the bucket
dumping angle to more than 20 °. The work equipment may be damaged.
• Keep ECSS switch turned OFF during leveling work.
1.
Scoop earth and sand into the bucket and then, while driv-
ing the machine in reverse, tilt the bucket forward to dump
earth and sand bit by bit to spread them.
2.
When leveling the ground, tilt the bucket forward so that
the bucket cutting edge touches the ground, then drag the
bucket by driving the machine in reverse.
3.
When performing finish leveling, scoop earth and sand into
the bucket, set the boom to FLOAT position with the buck-
et horizontal, and reverse the machine.
3-198
OPERATION