Binary B-900 Series Installation & Setup Manual page 20

13. Configure the MoIP Receivers
1. For displays that only support 1080p and/or HDCP 1.4, set the corresponding receiver to
match this requirement to allow video to pass. 4K video input into transmitters will not
show on 1080p and/or HDCP 1.4 displays.
2. Set each receiver individual to
this will allow the HDR metadata to pass resulting in 4K HDR 30Hz.
3. Set each receiver to 2160p 30Hz to displays that are 4K however; do not support HDR.
4. If desired, choose drop down for
If using a receiver with audio downmixing capability (B-900-MOIP-4K-RX-2AC):
5. Select the HDMI Audio setting:
(a) Auto - Determines the best audio
setting based on the signal chain.
(b) 2CH - Forces the source device to
only output 2 channel PCM.
(c) Bypass - Makes no modifications to
the incoming signal. It is possible in this
mode that an incompatible incoming
format results in no audio output from
the receiver.
6. If audio does not match the video, adjust the audio latency (up to 250 milliseconds). Audio
latency can be adjusted while streaming content. All other settings must be saved before they
take effect.
Note:
• The video output resolution can be set to 2160p (4K) at 30Hz or 25Hz or 1080p (2K) at
60Hz or 50Hz.
• Since each receiver always outputs 4K 30Hz 4:4:4 8 bit color. 4K HDR will be limited to 8-bit
color only; however, the display will show content as 4K HDR and output higher brightness
and contrast.
Passthrough for the displays capable of support 4K HDR as
Rotation (90°, 180°, or 270°).
20