Advertisement
19
Remove 2 screws in yoke (see insert).
Remove 3 screws with keyhole slots
from top of fan.
22
Hang fan from mounting bracket by
the hands free hook into a closed hole
on the edge of the Canopy.
Canadian mounting refer to Step #10.
25
Install blades and blade plates to
motor using the 9 motor screws pro-
vided. Tighten screws securely.
© 2013 Monte Carlo Fan Company
20
Smaller
holes
Place canopy on top of the fan motor allowing the
yoke, wires and safety cable to pass through the
large hole in the center of the canopy. Align the 3
larger holes around the center hole with the 3
screws still installed in the fan. Install 3 screws re-
moved into small holes in canopy to make it a flush
mount canopy and tighten screws securely.
23
Hands free hook
Lift fan to mounting bracket, aligning the "L"
shape holes with the scresws on the mount-
ing bracket. Turn the fan clockwise to lock
Note: For
in position. Install the other two screws and
tighten securely.
26
Loosen 2 screws with key slots and
remove 1 screw without slot from
motor plate and save screw.
Canopy
Center
Hole
Larger
holes
5
21
Install two screws corresponding with the
"L" shaped holes in the canopy only part
way so that canopy can twist into place.
Remove the all thread studs from the
lower part of the mounting bracket.
24
Align the blade and then the blade
plate with castings on motor to at-
tach blades to motor.
27
Install switch housing plate by twist-
ing plate with key hole slots into
place. Replace screw removed and
tighten the 3 screws securely.
Blade plate
7/1/2013
Advertisement
