How To Wire Your Ceiling Fan - Fanimation SHOWROOM TRIAIRE MAD8515 Series Manual

NOTE: If fan or supply wires are different colors than indicated, ha
1. To set the code on receiver unit, slide dip switches to
the same positions as set on the remote. (Figure 1)
NOTE: The remote unit has 32 different code
other remote units, simply change the combination code
NOTE: Factory setting is all up. Do not use this position.
WARNING
To avoid possible electrical shock, be sure electricity
s i u t n r e d o f f t a h t e m a
(Figure 2).
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
CAUTION: INCORRECT WIRE CONNECTION COULD
DAMAGE THIS RECEIVER.
2. Slide the receiver into the hanger bracket as shown in
Figure 3.
3. Connect wires using connectors as shown in Figure 4.
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors. Do not operate fan until the blades are in
place. Noise and motor damage could result.
4. After connections have been made, taking care not to
pinch the wires, put the white and green leads to one
side and the black leads towards the other side. The
wires should be spread apart with the grounded
conductor and the equipment-grounding conductor on
one side of the outlet box and the ungrounded conductor
on the other side. (Figure 5)

How to Wire Your Ceiling Fan

n i u f s e b o x b e o f e r w r i n i
WARNING
ON
1
g
GREEN-Ground Wire
From Ceiling
GREEN-Ground Wire
From Hanger Bracket
GREEN-Ground Wire
From Hanger Ball
GREEN / YELLOW
- Ground Wire (2)
From Receiver
GRAY
YELLOW
10
Dip Switch
2 3 4 5
Figure 1
Figure 2
Figure 3
Figure 4
RECEIVER HARDWARE USED:
WIRE
CONNECTORS
RED
Figure 5
MAIN FUSE BOX
NOTE: Supply wires
omitted for clarity
x 8
LISTED
OUTLET
BOX
WHITE
BLACK
BLUE
BLACK & WHITE