Table of Contents
Advertisement
Basic Settings Wizard
This section describes the configuration options available when you select "Basic Settings" from the
First Use Wizard / Welcome screen. You can select the "BACK" button, where available, to check
previous settings, as necessary.
Note: Each Basic Settings Wizard step is allotted a 10-second time frame after which the wizard
proceeds without user interaction. If default settings are appropriate, the wizard can proceed through
each of the configuration steps with no further user interaction. If you turn OFF the TV while the
wizard is in progress, when you turn the TV back ON, the First Use Wizard / Welcome screen will
be displayed. You will then have the opportunity to (re)initiate the desired configuration process.
Note: To exit the wizard at any time, use the arrow keys on the Installer Remote to select/highlight
button at the top right of the screen, and then press OK. In the exit confirmation screen, select
the
X
EXIT, and then press OK once more on the Installer Remote.
1. In the Language & Location screen, use the arrow keys on the Installer Remote to select/high-
light each appropriate field in turn—Language or Time Zone—and then press OK. Then, use
the up/down arrow keys to select the applicable value from the drop-down list of options for the
selected field. When you are ready to continue, use the arrow keys on the Installer Remote to
select NEXT, and then press OK.
Note: The Country field is inaccessible/grayed out because these models are only available in
the US. Also, if you allow the wizard to progress without specifying data in this screen, the time
zone will be set for "New York" (Eastern Standard Time).
LANGUAGE & LOCATION
Confirm your language and location settings.
Language
^
English
Country
^
Disabled
Timezone
^
Select...
BACK
NEXT
This wizard will continue automatically in 10 seconds.
2. The next screen enables you to configure the network settings of the TV. Refer to the appropriate
subsection(s) below for information on configuring the wired and/or wireless connection(s)
between the TV and the network. When you are ready to continue, use the arrow keys on the
Installer Remote to select NEXT, and then press OK.
Note: If desired, you can configure both wired and wireless connections. However, note that a
wired connection is always prioritized over a wireless connection. That is, when the TV is turned
OFF and then back ON, if a Local Area Network (LAN) is detected by the TV, the TV will default
to the wired connection. If the LAN cable is removed, the TV will then attempt to establish the
wireless connection. Whenever the TV is reconnected to the LAN, the TV will re-establish the
wired connection.
18
X
01
(Continued on next page)
206-4354
Advertisement
Table of Contents
