Sony AC-DN2A Operation Manual page 22

1 POWER indicator
The indicator lights up when the
power is turned on. This indicator
does not light up, however, when the
BP-L60(A)/L90(A) Lithium-Ion
Battery Pack is used as the back-up
power supply.
2 AC input connector
Connects to an AC power source
through an optional AC power cord.
3 DC output connector (4-pin)
Supplies DC power through the
supplied DC cable to the DNW-A220/
A220P or other portable device. The
No.4 pin is the plus connector and the
No.1 the minus.
4 Battery charging connector
(5-pin)
Supplies power for charging a BP-
L60(A)/L90(A) Lithium-Ion Battery
Pack.
The two outside pins are sensors
which block the charging current
when a battery other than a Lithium-
Ion Battery has been mistakenly
attached.
5 DC output connector (5-pin)
Supplies DC power to portable editors
and field editors, connected directly to
the AC-DN2A.
When the AC-DN2A is attached to a
Betacam SP camcorder, such as the
BVW-300/300P/BVW-400/400P,
through the optional BKW-L601 or
BKW-L601/1 Battery Adaptor, DC
power is supplied to the camcorder.
5 (E)