Panasonic KX-TG8102 Operating Instructions Manual page 38

Multi-unit Operation
3
"Register H.set" i #
4
Select a base unit number. i #
L This number is used by the handset
as a reference only.
5
Press and hold {x} on the base unit for
about 3 seconds, until the registration
tone sounds.
L If all registered handsets start ringing,
press {x} to stop, then repeat this
step.
L After pressing {x}, the rest of this
procedure must be completed within 1
minute.
6
Wait until "Enter Base PIN" is
displayed, then enter the base unit PIN
(default: "0000"), then press #.
L If you forget your PIN, see page 47.
L When the handset has been
registered successfully, w will stop
flashing. If keytones are turned on
(page 20), a confirmation tone will be
heard.
Selecting a base unit
When "Auto" is selected, the handset will
automatically use any available base unit it
is registered to. When a specific base unit is
selected, the handset will make and receive
calls using that base unit only. If the handset
is out of range of that base unit, no calls can
be made.
1
" (middle soft key) i N i #
2
"Select Base" i #
3
Select the desired base unit number, or
"Auto". i #
L The handset starts searching for the
base unit.
38
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Cancelling a handset
A maximum of 6 handsets can be registered
to a base unit. A handset can cancel its own
registration (or the registration of another
handset) that is stored in the base unit. This
will allow the base unit to "forget" the
handset.
1
" (middle soft key) i L i #
2
Enter "335".
3
"Cancel Handset" i #
L The numbers of all handsets
registered to the base unit are
displayed.
4
Select the handset(s) you want to
cancel, by pressing the desired handset
number. i #
5
"Yes" i # i {ih}
Cancelling a base unit
A handset can be registered to a maximum
of 4 base units. A handset can cancel a base
unit that it is registered to. This allows the
handset to "forget" the base unit.
1
" (middle soft key) i N i #
2
"Registration" i #
3
Enter "335".
4
"Cancel Base" i #
5
Select the base unit(s) you want to
cancel, by pressing the desired base unit
number. i #
6
"Yes" i # i {ih}
Note:
L To register the handset to another base
unit or to the same base unit again, see
manual registration (page 37).