The 3G Status Screen - ZyXEL Communications P8802T User Manual

Chapter 3 Device Info Screens
Each field is described in the following table.
Table 3 WAN Info Screen
LABEL
Interface
Description
Type
VlanMuxID
IPv6
Igmp
MLD
NAT
Status
IPv4 Address
IPv6 Address

3.4 The 3G Status Screen

Log into the VDSL Router's web configurator and click Device Info > 3G to view a summary screen
of information about the VDSL Router's 3G connection.
64
DESCRIPTION
This shows the name of the interface used by this connection.
A default name ipoa*, pppoa*, atm* or ptm* indicates DSL port. The ppp* indicates a
PPP connection via any one of the WAN interface.
The number after the dot (.) represents the VLAN ID number assigned to traffic sent
through this connection. The number after the underscore (_) represents the index number
of connections through the same interface.
(null) means the entry is not valid.
This is the service name of this connection.
0 and 35 or 0 and 1 are the default VPI and VCI numbers. The last number represents the
index number of connections over the same PVC or the VLAN ID number assigned to traffic
sent through this connection.
(null) means the entry is not valid.
This shows the method of encapsulation used by this connection.
This indicates the VLAN ID number assigned to traffic sent through this connection. This
displays N/A when there is no VLAN ID number assigned.
This displays whether or not IPv6 is enabled on the interface.
This shows whether IGMP (Internet Group Multicast Protocol) is activated or not for this
connection. IGMP is not available when the connection uses the bridging service.
This shows whether Multicast Listener Discovery (MLD) is activated or not for this
connection. MLD is not available when the connection uses the bridging service.
This shows whether NAT is activated or not for this interface. NAT is not available when the
connection uses the bridging service.
This displays the connection state or Unconfigured if the interface has not yet been
configured.
This displays the interface's current IPv4 address if it has one. Click connect to initiate the
WAN interface's connection.
This displays the interface's current IPv6 address if it has one. Click connect to initiate the
WAN interface's connection.
Basic Home Station VDSL2 P8802T User's Guide