Troubleshooting - Electrolux EWT 2064ESW User Manual

3.
12.7 Frost precautions
If the appliance is installed in an area
where the temperature can be less than
0 °C, remove the remaining water from
the inlet hose and the drain pump.
Do this procedure also when
you want to do the
emergency drain.
1. Close the water tap and disconnect
the water inlet hose.
2. Disconnect the drain hose from a
sink or spigot.
3. Put the ends of the drain and inlet
hose in a container. Let the water
flow out of the hoses.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 Introduction
The appliance does not start or it stops
during operation.
First try to find a solution to the problem
(refer to the table). If the problem
persists, contact the Authorised Service
Centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
• - The appliance does not fill with
water properly. Start the appliance
4.
4. Set the Drain programme and let it
operate until the end of the cycle.
5. Turn the programme knob to Stop to
disconnect the appliance from the
power supply.
6. Disconnect the appliance.
WARNING!
Make sure that the
temperature is more than
0°C before you use the
appliance again. The
manufacturer is not
responsible for damages
caused by low temperatures.
again by pressing appliance again by
pressing Start/Pause button. After 10
seconds the door will be unlocked.
• - The appliance does not drain
the water.
• - The appliance lid or drum
doors are open or not closed
correctly. Please check both!
• - The mains supply is unstable.
Wait until the mains supply is stable.
WARNING!
Deactivate the appliance
before you do the checks.
ENGLISH 19
90˚