Auto Standby Function; Installing The Soundbar On A Wall - Sanyo FWSB415E Owner's Manual

Auto standby function

• This soundbar will automatically go into standby mode for energy saving if no audio signal has been input for more than 20
minutes.
• In order to use the soundbar again while it is in standby mode, press

Installing the soundbar on a wall

1
Purchase the screws (x 2) by length/diameter below, now make screw holes on the vertical
interior wall.
• There is a "Wall mounting template" on page 21 or in the setup manual.
9/64"~5/32"/3.5~4 mm
2
Hang the soundbar over the screws.
NOTE(S)
• Use the "Wall mounting template" when you make the screw holes on the wall.
Print out the page 21 or use the setup manual and place "Wall mounting template" on the wall where the
soundbar is to be installed, to determine screw locations.
Funai is not liable for these types of accidents or injury noted below�
• Do not mount the soundbar onto the wall while your soundbar is plugged in or turned on.
It may result in an electrical shock injury.
• Install the screws on a sturdy vertical wall.
If installed onto a ceiling or slanted wall, the soundbar may fall which could result in a severe injury.
• Make sure that the wall where you are mounting the soundbar is appropriate.
Some mounts are not designed to be mounted to walls with steel studs or cinder block construction.
If you are unsure, contact a professional installer.
• Do not fasten the screws using excessive force.
This may damage the product or cause the product to fall, leading to an injury.
• Never allow children to climb on or play on the soundbar.
EN
5/32"/4 mm
>1-3/16"/30 mm
on the remote control.
(OPTIONAL)
Molly anchor
– 19 –