Table of Contents
Advertisement
5.3 LCD display (Option for LP-250 model)
This section lists the LCD display messages that you may encounter when operating the
printer. Also, it provides solutions.
Messages
Head Open
No Paper
Paper Jam
Out of Mem
Take Label
Cutter Error
Possible Cause
* The printer top cover is open.
* Running out of label.
* The label is installed incorrectly.
* Gap/black mark sensor is not
calibrated.
* Gap/black mark sensor is not
set properly.
* Make sure label size is set
properly.
* Labels may be stuck inside the
printer mechanism.
* The space of FLASH/DRAM or
MicroSD card is full.
* Peel function is enabled.
Waiting user to take label away
to print the next label.
* Cutter jam.
* There is no cutter installed on
the printer.
* Cutter or cutter driver circuit
board is damaged.
36
Recovery Procedure
* Please close the top cover.
* Supply a new label roll.
* Please refer to the steps in user's
manual to reinstall the label roll.
* Calibrate the gap/black mark
sensor.
* Calibrate the gap/black mark
sensor.
* Set label size correctly.
* Delete unused files in the
FLASH/DRAM or MicroSD card.
* Please take the label away to print
the next label if peeler module is
installed.
* If peeler module is installed and
label is been taken away, but the
message remains. Please check if
the peeler module connector is
connected to main board properly.
* If peeler module is not installed,
please disable the peeler function.
* Remove the jammed label.
* Make sure the media thickness is
equal or less than 0.19mm.
* Replace the cutter or cutter driver
circuit board.
Advertisement
Table of Contents
