Table of Contents
Advertisement
ASCII Data
Note:
1. Dump mode requires 2" wide paper width.
2. Turn off / on the power to resume printer for normal
printing.
3 Press FEED button to back to the previous menu
4.3.3 Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults.
Printer initialization is activated by the following procedures.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns green after 5 amber blinks. (Any green will do during
the 5 blinks).
•
The LED color will be changed as following:
Amber
red/amber (5 blinks)
Printer configuration will be restore to defaults as below after initialization.
Parameter
Speed
Density
Label Width
Label Height
Sensor Type
Gap Setting
amber (5 blinks)
red (5
solid green
127 mm/sec (5 ips) (203DPI)
8
2" (50.8 mm)
4" (101.6 mm)
Gap sensor
0.12" (3.0 mm)
green (5 blinks)
Default setting
31
Hex decimal data related to
left column of ASCII data
green/amber (5 blinks)
Advertisement
Table of Contents
