Using Ethernet Interface To Setup Ethernet Interface - Brecknell LP250 User Manual

3.4.2 Using Ethernet interface to setup Ethernet interface

1. Connect the computer and the printer to the LAN.
2. Turn on the printer power.
3. Start the Diagnostic Utility by double clicks on the
Note: This utility works with printer firmware V6.00 and later versions.
4. Select Ethernet
"
subnet mask and gateway for the on board Ethernet.
5. Click the Discover Device
"
6. Select the printer in the left side of listed printers, the correspondent IP address will be
shown in the right side
7. Click Change IP Address
"
The default IP address is obtained by DHCP. To change the setting to static IP address,
click Static IP
"
as the interface then click on the
"
button to explore the printers that exist on the network.
"
IP address/Printer Name
"
to configure the IP address obtained by DHCP or static.
"
radio button then enter the IP address, subnet mask and gateway. Click
"
Setup button to setup the IP address,
" "
field.
"
21
icon.