Advertisement
Available languages
Available languages
e tool
- Fully unroll the appliance's power cable before each use.
e that
- Do not use the appliance if its accessories are not
power
n the
- Do not use the appliance if the accessories or
consumables attached to it are defective. Replace them
orque
immediately.
- Do not use the appliance if the on/off switch does not
gainst
work.
- Do not force the appliance's work capacity. Use the
correct power tool for each application. The correct power
ttery,
tool will do the job better and safer at the rate for which it
seek
was designed.
s can
- Do not open the battery/ies under any circumstances
whatsoever.
- Do not short-circuit the battery terminals as this may
cover
- The battery/ies should be stored at a temperature of
below 40ºC.
either
- Disconnect the battery charger from the mains when not
as this
in use and before undertaking any cleaning task.
- Remove the batteries from the appliance if you are not
aged.
going to use it for some time.
label
- This appliance is not a toy. Children should be supervised
n the
to ensure that they do not play with the appliance.
- This appliance is intended for adult use. Ensure that this
diately
product is not used by the disabled, children or people
nt the
unused to its handling.
- This appliance should be stored out of reach of children
and/or the disabled.
- Keep the appliance in a dry, dust-free place, out of direct
sunlight.
ngled
- Let the appliance running with no load for 30 seconds
in a safe position. If you notice serious vibration or other
cord
defects stop the appliance immediately. Then check the
problem and /or proceed as we describe on Anomalies and
Repair clause.
orked
ree to
Description
while
1
Keyless chuck
2
Torque adjustment ring.
ion of
3
Cooling vents
s and
4
Soft grip
pment
5
Power light
safety
6
Forward/reverse switch
7
On / Off / speed adjustment switch
silica
8
Battery release button
your
9
Battery
dust,
10
Function ring
cident
11
Charger base
12
Gear Selector
gas or
13
Charger
14
Battery indicator
Installation
Charging the battery
- Caution: A new battery is not fully charged and must
therefore be charged before the appliance is used
- Caution: The power supplier for this charger should
be protected by a residual current device(reted at
30mA or less). A residual current device reduces the
risk of electric shock.
- Charge the battery at an atmospheric temperature
of between 4 and 40ºC.
- Plug the charger (13) into the mains. And no lights
on.
- Remove the battery (9) from the appliance by
pressing the battery unlocking button (8) and pulling
the battery out of the appliance
- Plug charging jack into charging base. The green light
will illuminate when connected.
- Insert the battery into charging base . The red & green
light will illuminate when properly connected & charging.
- The green light will illuminate when the battery reaches full
charge.
Check battery charge
- Press the on/off switch (7) and the
indicate the level of charge.
Instructions for use
Before use:
- Make sure that all the product's packaging has
been removed.
- Prepare the appliance according to the function you
wish to use:
Insert a drill bit:
- To open the drill's chuck (1), whilst completely
turn the chuck counter clockwise.
5
battery indicator light will
Advertisement
