Table of Contents
Advertisement
Landing Gear & Battery Installtion
Battery Straps
( Accessories Bag )
Front Landing
Gear Support
380 - CF Bottom Plate
Main Blades Installation
M3x18 Hex Cap Screw
M3 Self Lock Nut
page 34
Satellite
EX
6xM2.5 Washer
Rear Landing
4xM2x5
Gear Support
Button Screw
( Add loctite 243 )
383mm Main
( Use 0.5mm Shim thickness for
Zeal 383mm Main Blade )
Main Blade Lock Note:
In small Heli or in aggressive head design
like oxy 2, 3 and 4 if you fly on hard terrain
MUST set loose.This suggestion will avoid
annoying wobbling on ramp up or landing.
Please look at Accessories for the shims you need
to adjust Main & Tail Blades thickness, in the kit
have included:
1 Set x OXY4 - Main Blade Shim Silver = 0.5mm thickness
1 Set x OXY4 - Main Blade Shim Black = 0.6mm thickness
1 Set x OXY4 - Main Blade Shim Red = 0.75mm thickness
1 Set x OXY4 - Tail Blade Shim Black = 0.5mm thickness
6xM2.5x8
Hex Cap Screw
( Add loctite 243 )
Tail Blades Installation
Tail blade need be loose. Set it free to rotate.
About lock thread, to assure the Screw M2x 10
use it but carefully. Apply small amount of lock
thread NOT in the Screw but in the Tail Grip Thread,
using a tooth pick. Be careful about lock thread
contamination on plastic tail blade, lock thread
contains chemical that effect plastics, reducing strength.
After assembly clean carefully any lock thread
excess to avoid contamination effect.
Chapter 17: Landing Gear & Battery Installtion
Landing Gear Skid
M2.5x10
Button Screw
Tail Blade 70mm
( Box 3 / Bag 8 )
2.5x12x0.5 Shim
( Accesories )
Advertisement
Table of Contents
