Remote 2 In> Terminal - Panasonic PT-DX810E Operating Instructions Manual

<REMOTE 2 IN> terminal
It is possible to control the projector remotely (by external contact) from a control panel located away from the projector where remote control
signals cannot reach. Use the <REMOTE 2 IN> terminal on the connecting terminals of the projector to connect to the control panel.
Meeting room or other installation location
Pin assignments and signal names
D-Sub 9-pin (Outside view)
(6) (9)
(1) (5)
Attention
f When controlling, make sure to short-circuit pins (1) and (9).
f When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control cannot be used.
The power on < b > button, the power standby < v > button, the <SHUTTER> button, and the RS-232C commands and network functions
corresponding to these functions cannot be used either.
f When pins (1) and (9) are short-circuited, do not short-circuit any pins from (3) to (7) with pin (1). The following buttons on the control panel
and the remote control cannot be used.
The power on < b > button, the power standby < v > button, <RGB1> button, <RGB2> button, <DVI-D> button, <VIDEO> button, <S-VIDEO>
button, <HDMI> button, <SHUTTER> button, and the RS-232C commands and network functions corresponding to these functions cannot
be used either.
Note
f For pin (2) to pin (8) settings, you can make changes if you set [REMOTE2 MODE] to [USER] ( x page 81).
124 - ENGLISH
Chapter 6 Appendix — Technical information
Pin No. Signal name
(1)
(2) POWER
(3) RGB1
(4) RGB2
(5) VIDEO
(6) S-VIDEO
(7) DVI-D
(8) SHUTTER
(9) RST/SET
Remote control
Remote control/Contact control
Standby
RGB1
RGB2
DVI-D
Remote control panel in another location
Open (H)
GND ―
OFF
Other
Other
Other
Other
Other
OFF
Controlled by remote
control
Contact control
Lit
Lamp
VIDEO
S-VIDEO
HDMI
Short (L)
GND
ON
RGB1
RGB2
VIDEO
S-VIDEO
DVI-D
ON
Controlled by external
contact