Start; Add 30 Seconds; Stop Cancel; Tones - KitchenAid YKMCS1016 Use & Care Manual

Function Icons
A
E F
A. Microwaves
B. Defrost
C. Power (high)
D. Power (low to mid)
E. Time
The icons light up in the display while their specific functions are
being programmed. While the set function is operating, the icons
flash until the program is over. The Control Lock icon remains lit
– not flashing – while the control is locked.
When the microwave oven is in use, the display will show cook
time remaining, and the function icons will flash. When the
microwave oven is not in use, the display will show the time of
day (if the clock is set) or Timer countdown (if the Timer is set).
The Start keypad begins any function. If non-sensor cooking is
interrupted by opening the door, touching START will resume the
cycle.
NOTE: To avoid unintentional operation of the microwave oven,
a cooking function cannot be started if the microwave oven
door has been closed for about 5 minutes. The word "door"
will appear in the display until the door is opened and closed.

Add 30 Seconds

The Start Add 30 Sec keypad automatically starts the microwave
oven at 100% power for 30 seconds, and it adds 30 seconds of
cook time with each additional touch of the keypad.
Time may be added to any manual cooking cycle in 30-second
increments, at the current power level, by touching Start Add 30
Sec during cooking.
NOTE: To avoid unintentional operation of the microwave oven,
a cooking function cannot be started if the microwave oven
door has been closed for about 5 minutes. The word "door"
will appear in the display until the door is opened and closed.

Stop Cancel

The Stop Cancel keypad clears any incorrect command and
cancels any program during cooking. It will not erase the time
of day.
The microwave oven will also turn off when the door is opened.
Close the door and touch START to resume the cycle.
The Stop Cancel keypad is also used to lock and unlock the
control panel. See the "Control Lock" section.
Tones are audible signals that may be turned off. These tones
indicate the following:
One tone
Valid entry
■
Control Lock activated or deactivated
■
B C D
Oz lbs
G H I
F. Control lock
G. Menu program
H. Ounces
I. Pounds

Start

Tones

Two tones
End of Convection Bake preheat
■
Three tones
End of Timer countdown
■
Five tones
End of cooking cycle
■
This is a standard 12-hour clock (12:00-11:59). The Clock cannot
be erased. If the Clock is not set, "0:00" will remain in the display
when the microwave oven is not in use.
To Set:
The microwave oven and Timer must be OFF.
1. Touch CLOCK.
2. Touch the number keypads to enter the correct time of day.
3. Touch CLOCK.
The Timer can be set in minutes and seconds, up to 99 minutes
99 seconds, and counts down the set time.
NOTE: The Timer does not start or stop the microwave oven.
Cook functions may be used while the Timer is counting down.
When the cook function is active in the display, touch TIMER to
see the Timer countdown for about 5 seconds.
To Set:
1. Touch TIMER.
2. Touch the number keypads to enter desired time.
3. Touch START.
When the set time ends, "End" will appear in the display and
the end-of-Timer tones will sound.
4. Touch STOP CANCEL while the Timer is active in the display
to cancel the Timer.
The time can be reset during the countdown by canceling Timer,
and then repeating the above steps.

Control Lock

The Control Lock disables the control panel keypads to avoid
unintended use of the microwave oven.
To Lock/Unlock Control: The microwave oven must be Off.
Touch and hold STOP CANCEL for about 3 seconds, until the
tone sounds and the Control Lock icon appears in the display.
Repeat to unlock.
If any keypad is touched while the control is locked, there will
be no response from the control.

Language

The default display language is English, but it may be set to
French. Two display messages are affected: "End" (English) or
"Fin" (French), and "door" (English) or "PrtE" ("porte" - French).
To Set Language to French: Within 5 minutes of power-up,
touch and hold POWER LEVEL for about 5 seconds, until a
tone sounds. To set back to English, disconnect power, then
reconnect power to microwave oven.

Weight Entry Mode

The Default Weight Entry mode for Defrost is imperial (pounds),
but may be set to metric (grams). This setting does not affect
any other program besides Defrost. See the "Defrost" section.
To Set Weight Entry to Metric: Within 5 minutes of power-up,
touch and hold number "0" keypad for about 5 seconds, until
a tone sounds. To set back to imperial, disconnect power, then
reconnect power to microwave oven.

Clock

Timer

7