Installation; Installation Guidelines; Installing The Switch Without A Rack - D-Link DXS-3600 Series Hardware Installation Manual

Installation

Installation Guidelines

Installing the Switch without a Rack

Installing the Switch into a Rack
Installing Transceivers into the Transceiver Ports
Installing Power Modules into the Power Module Ports
Installing Fan Modules into the Fan Module Ports
Installation Guidelines
This section will discuss the hardware installation guidelines that the user must follow in order to properly and safely
install this switch into the appropriate environment.
 Visually inspect the power cord and see that it is fully secured to both the power connector, on the switch, and
the electrical outlet, that supplies power.
 Install the switch in a fairly cool and dry place within the acceptable temperature and humidity operating
ranges.
 Install the switch in a site free from strong electromagnetic field generators such as motors, vibration, dust,
and direct exposure to sunlight.
Installing the Switch without a Rack
This section is used to guide the user through installing the switch in an area other than a switch rack. Attach the
rubber feet included to the bottom of the switch. Take note that there should be marked blocks on the bottom of the
switch to indicate where to attach the rubber feet. These marking are usually found at each bottom corner of the
device. The rubber feet cushion the switch, protecting the casing from scratches and preventing it from scratching
other surfaces.
Install the switch on a sturdy, level surface that can support the weight of the switch (see the Appendix section for the
Weight specifications of this switch). Do not place any heavy objects on the switch. The power outlet should be within
1.82 meters (6 feet) of the switch. Make sure that there is proper heat dissipation from and adequate ventilation
around the switch. Leave at least 10 cm (4 inches) of space at the front and rear of the switch for ventilation.
DXS-3600 Series 10GbE Layer 2/3 Switch Hardware Installation Guide
Figure 2-1 Prepare the Switch for installation on a desktop or shelf
14