Sanyo LV-7300 Owner's Manual page 17

Table of Contents

Advertisement

Remove the battery
1
compartment lid.
Press the lid
downward and
slide it.
To insure safe operation, please observe the following precautions :
Use (2) AA type alkaline batteries.
Replace two batteries at the same time.
Do not use a new battery with a used battery.
Avoid contact with water or liquid.
Do not drop the remote control unit.
If batteries have leaked on the remote control, carefully wipe the case clean and load new batteries.
Operating Range of the Remote Control
Point the remote control toward the projector (Receiver Window) whenever pressing the buttons. Maximum
operating range for the remote control is about 16.4' (5m) and 60° front and rear of the projector
FRONT
Remote Control Batteries Installation
Slide the batteries into
2
the compartment.
For correct polarity (+ and –), be sure
the battery terminals are in contact
with the pins in the compartment.
16.4'
(5 m)
60°
BEFORE OPERATION
Replace the compartment
3
lid.
Slide the lid
upward.
REAR
16.4'
(5 m)
60°
17

Advertisement

Table of Contents
loading

Table of Contents