Connecting To The Macintosh Computer - Sanyo LV-7300 Owner's Manual

CONNECTING THE PROJECTOR
CONNECTION TO THE MACINTOSH COMPUTER
To connect with the Macintosh computer, refer to the figure below.
Used cables for connection
• VGA CABLE
• CONTROL CABLE FOR ADB PORT
• MAC ADAPTER
• MONITOR CABLE
• PC AUDIO CABLE (stereo)
These cables are not supplied with this projector.
NOTE :
When connecting the cable, the power cords of both the projector and the external equipment should be
disconnected from AC outlet. Turn the projector and peripheral equipment on before the computer is switched
on.
MACINTOSH COMPUTERS (VGA / SVGA / XGA / SXGA)
14
Desktop type
Monitor
To the Monitor
Monitor Output
MAC Adapter
Set the switches depending
ON DIP
on the RESOLUTION MODE
1 2 3 4 5 6
that you want to use before
your turn on the projector
and computer
VGA Cable
Monitor Cable
Laptop type
To each terminal of your computer
ADB port Audio Output
Terminal
Control Cable for ADB Port
Audio Speaker
(stereo)
Audio Amplifier
Audio Input
Audio Cable
(stereo)