Accessories - RedMax GZ500 Operator's Manual

Recommended bar lengths, inch/cm
Pitch, inch/mm
Thickness of drive links, inch/mm
Type of drive sprocket/number of teeth
Saw chain speed at 133% of maximum engine power
speed, ft/s / m/s
Recommended cutting equipment
A specific chainsaw model has to be evaluated with the
cutting equipment to be recommended and fulfill the
requirements in ANSI B175.1-2012 (Internal Combustion
Engine-Powered Hand-Held Chainsaws - Safety and
Environmental Requirements) and Canadian Standards
CSA Z62.1-15 (Chainsaws) and CSA Z62.3-11 (R2016)
(Chainsaw kickback).
Chainsaw model RedMax GZ500 meet the safety
requirements in ANSI B175.1-2012 and Canadian
Standards Association CSA Z62.1-15 (Chainsaws) and
CSA Z62.3-11 (R2016) (Chainsaw kickback), when
equipped with the below listed saw chain and guide bar
combination(s).
Guide bar
Length, in Pitch, in
13 0.325
15
16
18
20
13 0.325
15
16
18
20
1513 - 001 - 25.06.2020

Accessories

Gauge, in Max. nose ra-
dius
0.050 10T
0.058 10T
12T
GZ500
13-20/33-51
0.325/8.25
0.058/1.5, 0.050/1.3
Spur/7
75.5/23.1
Note: Other chainsaw models may not meet the
kickback requirements when equipped with the listed
guide bar and saw chain combinations.
We recommend only to use the listed guide bar and saw
chain combinations.
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is specified by
the number of teeth, such as 10T. For solid guide bars
the nose radius is specified by the dimension of the
nose radius. For a given guide bar length, you can use a
guide bar with smaller nose radius than given.
Saw chain
Type
RedMax
SP33G
RedMax H30
RedMax H25
Low kickback Length, drive
links (no.)
Yes 56
64
66
72
*
78/80
Yes 56
64
66
72
*
78/80
33