Frigidaire FGEF302TPF Use & Care Manual page 14

setting oven controls
minimum and maximum control Pad settings
All of the features listed below have minimum and maximum time or temperature settings that may be entered into the
control. An ENTRY acceptance beep will sound each time a control pad is touched (the acceptance beep on the Oven
Lockout pad is delayed 3 seconds).
An ENTRY ERROR tone (3 short beeps) will sound if the entry of the temperature or time is below the minimum or
above the maximum settings for the feature.
Feature
QUICK PREHEAT
BAKE
BROIL
WARM
PIZZA
TIMER
CLOCK TIME
DELAY TIME
BAKE TIME
CLEAN TIME
IMPORTANT THINGS TO KNOW BEFORE
setting anY oven cooking Feature
This appliance has been factory pre-set to start any
BAKE, WARM or Quick PreHeat feature with the
oven set temperature automatically set for 350°F. The
BROIL feature is pre-set at 550°F. However if desired,
the oven set temperature may be adjusted at any
time during the cooking process. You may also choose
to add a BAKE TIME or delaY time with most of
the functions listed above, unless specified in their
corresponding section.
setting tHe clock
The set clock pad is used to set the clock. The clock
may be set for 12 or 24 hour time of day operation.
The clock has been preset at the factory for the 12 hour
operation. When the range is first plugged in, or when
the power supply to the range has been interrupted, the
timer in the display will flash.
to set the clock (example below for 1:30)
1. Press set clock. "clo" will appear in the display.
2. Press 1 3 0 pads to set the time of day to 1:30.
"clo" will stay in the display.
3. Press start. "clo" will disappear and the clock will
start.
14
minimum temP. /time maximum temP. /time
170°F/77°C
170°F/77°C
400°F/205°C
170°F/77°C
400°F/205°C
12 Hr. Mode 0:01 Min.
24 Hr. Mode 0:01 Min.
12 Hr. Mode 1:00 Hr./Min.
24 Hr. Mode 0:00 Hr./Min.
12 Hr. Mode 1:00 Hr./Min.
24 Hr. Mode 0:00 Hr./Min.
12 Hr. Mode 0:01 Min.
24 Hr. Mode 0:01 Min.
2 hours
CHANGING BETWEEN 12 OR 24 HOUR
time oF daY disPlaY
1. Press and hold set clock for 6 seconds. "clo" will
2. continue holding the pad until "12Hr daY" or
3. Press clean to switch between the 12 and 24 hour
4. Press start to accept the change or press oFF to
5. Reset the correct time as described in to set the
550°F/288°C
550°F/288°C
550°F/288°C
170°F/77°C / 3 hours
425°F/218°C
11:59 Hr./Min.
11:59 Hr./Min.
12:59 Hr./Min.
23:59 Hr./Min.
12:59 Hr./Min.
23:59 Hr./Min.
11:59 Hr./Min.
11:59 Hr./Min.
4 hours
appear in the display.
"24Hr daY" appears in the display and the control
beeps once.
time of day display. The display will show either
"12Hr daY" or "24Hr daY".
reject the change.
clock above. Please note that if the 24 hour time
of day mode was chosen, the clock will now display
time from 0:00 through 23:59 hours.